When deciding on your own, you need the following materials at hand: scissors, brush or roller for distributing glue, brush or roller that will help to smooth the wallpaper, it would be nice if there was a spatula or rag.
Firstly, we measure the length of the wallpaper, add a few centimeters to it, which will be needed to eliminate the floor irregularity, and then cut the required number of rolls.
If you use glue, then try not to touch the front of the wallpaper canvas them. In this case, it is necessary to put the paper under the lower canvas, and the stack is shifted by the longitudinal side to the edge of the object on which the roll lies.
It is best to spread the glue with a brush or roller, while it is evenly distributed throughout the wallpaper canvas. Keep in mind that the entire surface of the canvas should be in glue. Wallpapers glue to resort to two methods: vomiting or. Visit the online store of building materials and buy STSGEO geomaterials.
Thick wallpaper is usually glued. At the same time, it is best to glue the wallpaper together. One holds, the other spreads glue.
If you glue the wallpaper, then it is necessary to start pasting from the window so that the shadows from the seams do not appear..
If you did not have time to remove the skirting board, then the wallpaper needs to be pulled under the baseboard with a spatula, and the rest of the lower part of the roll is trimmed with a strip and glued on top, closing the seam and part of the skirting board. If it is possible to remove the skirting board, it needs to be dismantled and glued to all the walls to the floor, and attach to the place of the skirting board.
All power networks and sockets before pasting, it is necessary to remove, while you should turn off the electricity. After the wall is covered with wallpaper, holes are cut out in those places where there were sockets.
When pasting the wallpaper close to the ceiling, it is necessary to turn the edge of the canvas by 5 cm, this is necessary in order not to touch the ceiling with glue. The wallpaper roll must be tightly pressed against the wall at the top, and after the verticality of the roll is checked, it must be smoothed out with the movements of the brush down. Similarly, glue all other rolls. After pasting, the room must be set aside for drying, while it is better not to open the doors and windows. After these procedures, ventilate the room, from the smell of glue and you can bring and arrange furniture.