If you want to put the lock on your door yourself, then remember: you can do this only with a wooden door. Metal locks in the door of the door should only be engaged in professionals.
So, in order to install the lock on a wooden door, we will need the following tools: actually a lock, pencil, ruler, twisted or feather drill, construction knife, screws, screwdriver, chisel and drill.
First, we plan the position of the lock relative to the door, put the point in the place of the cut, apply the inside of the lock on it and circle its contour with a pencil. Then we mark the location of the fasteners, mark the exact height of the rod and the keyhole, double -check the resulting drawing.
Then it draws a perfectly even line from the door of the door and correlate the thickness of the latter with the depth of the keyhole. We mark on a drill with a diameter slightly larger than the thickness of the lock mechanism obtained result. By the way, you can use special cords for key. Then we drill holes along the axial line on the edge.
We note the position for the handle of the latch and the place of the keyhole on the front side of the door, after which we drill both sides alternately. They must converge in the center. Then, using a chisel, we process the gross ends and remove the excess. The main thing here is not to overdo it. We redesign the work several times, the coincidence of the holes and insert the castle body. Collect the overlay of the case, install the rod and handle with screws. We do not fully cover the door and transfer to the end of the lower and upper position of the latch, after which we open the door and draw the line with a pencil.
Finally, we make a seizure for latch. Cover the door again and circle the latch on the front side of the door. Put the locking bar to the marking and circle. Then we cut out the exhaust with a chisel, install the bar and fix it with screws.
So, the lock is inserted, now you can paint the door or overtake it with any material.