In order to achieve the maximum result, it is enough to reliably install two supports on one side. The wedges need to be scored in several stages, with little force tapping in three directions from the center of the bathroom to its sides. If the supports are fixed using a tightening bolt, then you need to install without tapping. Sometimes there are small surfaces on the supports. It is enough to grind them carefully using a grinder. Before fixing the supports, it should be installed on them adjusting bolts with fixing control nuts. When repairing the bathroom, also do not forget to change the old bath to a new.
It is necessary to remember the basic rule: the control nut is located below the support, regardless of the type of bath. The wedge needs to be scored until the maximum fixing of the bath is reached. If you overdo it at this stage, you can damage the product. At the next stage, you need to connect the withdrawal to the siphon, and to the sewer – the release. Next, you need to install a bath on the existing supports, and on the other side of it, build a temporary support. This support needs to be insured. After the bath is installed, you can extract temporary insurance and install additional supports. Having checked the reliability of the resulting design, you can proceed to its adjustment.
About the author
I was born on July 24, 1975 in a small mining town located in the Kemerovo region. In a turning point in 1992 he graduated from a school with a silver medal and decided not only to enter a higher educational institution, but to radically change his life. To embody the ambitious plans, I had to attach
Read more