Due to the periodic shutdown of hot water, the presence of a boiler becomes necessary.
In some cases, it will not be needed periodically, but constantly. If you decide to install a boiler at home, then first of all you will have to choose between the accumulative and flow. But the latter buy much less often, because they have a lower volume and higher cost.
If you feel that you can’t cope with the installation yourself, then it is better to immediately contact the Ustanovka-Boilerov specialists who know their work very well. For independent work, you should clearly observe the rules that professionals give. Before starting work, turn off the electricity and block the supply of cold water.
First of all, you should make a mount for the boiler and choose a place for installation. The wall for fastening should be reliable to withstand the boiler hanging on it without problems. In no case do not install it on a drywall wall. To determine the place of fastening, mark the lower point of the boiler on the wall. Measure the distance from the lower edge to fasteners on a boiler. The boiler will be fixed for fastening by hanging.
To facilitate you will need a punch with a win drill for a brick or concrete wall. If the wall is wooden, then the usual drill is enough. The diameter should be slightly less than the dowel. Anchor screw to a depth of at least 10 cm. Now you can hang our unit.
We will connect a boiler using flexible hoses to the water pipe. If desired, you can use plastic and metal -plastic pipes, but this will extend and complicate the work. We connect the pipe with a red mark with a cold water pipe, with blue – with hot. On a cold water pipe, we also install a safety valve. If it is not in the kit, then it will have to buy it separately. It will not be superfluous to put the crane between the water pipe and the boiler, which will disconnect it if necessary.